GOOT Goodyear Controlled Automatic Tin Suction Pump TP-250AS
1. Through holes suck tin, multilayer printed circuit boards suck tin.
2.Super strong suction power
TP-250AS is equipped with two powerful diaphragm pumps. The design of the open valve is added, and the vacuum degree can reach -0.06MPa (about -450mmHg) in only 0.1 second.
Compared with the TP-200 / 200AS, the TP-250AS reaches the highest vacuum degree at a speed higher than 4 times.
3.Free temperature setting
The temperature can be set freely in the range of 250 ~ 450 ° C. Equipped with sensor feedback temperature system.
4. Rapid heating, high thermal recovery force, the nozzle quickly heats up, and can be used after two minutes when set at 450 ℃.
5, prevent the suction nozzle from blocking the structure When the start switch is ON, the heating core is forced to heat, which effectively prevents the temperature from decreasing during the suction operation.
6. Replaceable filter The installation and replacement of the filter is simple.
110V, 220V AC 50 / 60Hz
Temperature setting range
250-450 ° C
Built-in ceramic heating element in sensor
Temperature control method
Sensor feedback (ON-OFF control)
Insulation resistance (500V DC)
100MΩ or more
Vacuum pump method
Air source type
Degree of vacuum
0.5Mpa (5.0kgf / cm2)
0.7Mpa (7.0kgf / cm2)
95 (W) x256 (L) x205 (H) mm
2.6kg (excluding power cord and hose)
2.0kg (excluding power cord and hose)
0.3kg (excluding power cord)
0.1mV or less
0.3Ω or less
Power cord / hose
Power cord length
1.5m (3-core wire, with grounding plug)
TP-100CP07, soldering station ST-76